WEST SYSTEM Six10 - All you need to do is Squeeze
WEST SYSTEM® Six10™
All you need to do is Squeeze!
WEST SYSTEM Six10™
is a pre-thickened, gap filling epoxy with a smooth non-sagging
consistency that trowels easily - perfect for filling voids and making
Six10 adhesive provides similar characteristics to 105
resin and hardener thickened with 403 Microfibre Blend, but with the
advantage of being pre-mixed and applied straight from the cartridge for
point and shoot convenience with any standard caulking gun. It is
ideal for stitch and glue boat construction, fibreglass laminate repair
and general bonding, and it bonds to a wide range of materials including
wood, metals, composites and masonry.
A unique piston inside the
cartridge simultaneously dispenses the resin and hardener from the
separate chambers and accurately controls the ratio. The resin and
hardener are separated from contacting each other until they are outside
should be noted when doing smaller jobs, you don't have to use the
static mixer. Simply squeeze out the amount needed onto a piece of
plywood or board, mix the resin and hardener together thoroughly, and
then apply to the job with a mixing stick or plastic spreader.
The hardener provides a long open time but has fast through-cure. Six10
stays workable in the static mixer for 42 minutes at 25°C, making it
practical for long or complicated assemblies, and cures in temperatures
as low as 10°C. It cures to a solid state in 5 – 6 hours at 25°C and
will take high loads in 24 hours.
Place high-strength, non-sagging epoxy exactly where
it's needed in less time and with no mess
The coaxial cartridge contains 190ml of resin and hardener and additional static mixers are available in packs of 2.
Recommended Retail $32.00 inc gst
Available from WEST SYSTEM Dealers throughout Australia
Click on link below to view a short video